DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Install Additional Hardware

Replace a TN750 or TN750B with a TN750C or Move all Announcements from a TN750B to a TN750C

Return to Task List


Note: Do not copy or restore announcements from a TN750C to a TN750 or TN750B circuit pack, as this may corrupt the announcement data.

  1. Save announcements from the TN750/B to the mass-storage system.

  2. Insert the TN750C circuit pack into a vacant slot of a carrier.

    3. Any carrier is acceptable since power holdover is not a concern.

  3. Lift the locking lever upward until the latch pin engages.

  4. Administer a new data module on the TN750C circuit pack, as described in DEFINITY Enterprise Communications Server Administrator's Guide.

  5. Type restore announcements and press Enter to the TN750C circuit pack equipment location.

  6. Wait until announcements copy from voice RAM to flash memory (yellow LED on the TN750C stops flashing). This may take about 10 minutes.

  7. Type busyout board 01c11 and press Enter for the TN750/B circuit pack, where "01c11" is an example circuit pack location.

  8. Type change integrated announcements and press Enter.

    9. This modifies the translations for the TN750B circuit pack to reference the TN750C circuit pack.

  9. Verify proper playback of the announcements from the TN750C circuit pack by calling them.

  10. Type release board 01c11 and press Enter for the TN750/B circuit pack, where "01c11" is an example circuit pack location.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.