DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Install and Connect Modems

Add U.S. Robotics Model USR 33.6 EXT External Modem to EPN

Return to Task List

  1. Connect an RS-232 cable to the modem. See Connect External Modem to EPN.


Note: In the following steps, a PC with Windows 95 or Windows NT 4.0 may be substituted for the dumb terminal. Use the Hyperterminal (terminal emulation) application.

  1. Connect the opposite end of the RS-232 cable to a dumb terminal.

  2. Set the dumb terminal to full duplex mode.

  3. Type AT&N6 to set the baud rate to 9600.

    4. The modem connects at 9600 baud but throughput is at 1200 baud.

  4. Type AT&W0 to save the setting into non-volatile RAM.

  5. Set Switch 5 to the OFF (up) position to disable auto answer.

  6. Disconnect the RS-232 cable from the terminal and connect it to the TERMINAL connector on the rear of the system cabinet.

Connect External Modem to EPN

Figure Notes:
      1. U.S. Robotics External Modem

      2. RS-232 Cable

      3. Expansion Port Network

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.