DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Release 9si to R10si

Check link status

Return to Task List

  1. Type display communication-interface links and press Return.


Note: ISDN-PRI D-channel links no longer appear on this screen. (ISDN-PRI resides on the network packet circuit pack.) The only way to determine if an ISDN-PRI D-Channel is up is to use the status signaling group command.

  1. Type status link number and press Return. Repeat this step for each type of administered link.

  2. Check that DS1 trunks and BRI phones are functioning normally.

  3. Type list signaling-group press Return.

  4. For each signaling group, type status signal < number > and press Return.

  5. Ensure that the Group State field is in-service.

  6. Execute the following commands and verify that the information is correct:

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.