Check the Active Tone-Clock (High/Critical reliability only) [R9r]
Return to Task List
- Type
status port-network 1 and press
Enter to verify that the Tone-Clock and the active SPE are in the same carrier.
- Verify that the
Service State field shows
in.
- If the Tone-Clock and active SPE are
not in the same carrier, type
set tone-clock [A | B] and press
Enter
.This command sets the Tone-Clock to the same carrier as the active SPE.
If the active Tone-Clock has not migrated to the active carrier after 1 minute, then a Tone-Clock problem exists. Refer to the TDM-CLK Maintenance Objects section of the
DEFINITY Enterprise Communications Server Release 9 Maintenance for R9r book to resolve any problems.
Return to Task List
