Table: Platform Alarms
|
Alarm Message
|
Repair Action
|
|
CMOS Battery Error
|
|
|
CMOS Checksum Error
|
- Replace the motherboard.
- If Step 1 does
not work, run the CMOS setup.
|
|
Display Card Mismatch
|
|
|
Diskette Drive Controller Error or Not Installed
|
Check the diskette cable connections.
|
|
Diskette Drive Error
|
Diskette may be defective. If the diskette is good,
replace the diskette drive. |
|
Diskette Drive A Type Mismatch
|
Run the CMOS setup
and select the proper drive type. |
|
Diskette Drive B Type Mismatch
|
Run the CMOS setup
and select the proper drive type. |
|
Equipment Configuration Error.
|
Check the memory configuration:
- Check the MAP/5PV4
DIMM seating.
- Check the CMOS
setup.
|
|
Hard disk Controller Error
|
|
|
Hard disk 0 Error
|
Check all cable connections.
|
|
Keyboard Error or No Keyboard Connected
|
Check and connect the keyboard to the MAP/5PV4.
|
|
Keyboard Interface Error
|
Replace the keyboard.
|
|
Memory Error at:
MMMM:SSSS:OOO
(W:XXXX, R:YYYY)
where:
M is Mbytes, S is Segment, O is Offset, X/Y are write/read pattern
|
For the MAP/5PV4, replace the DIMM. |
|
CPU Clock Mismatch
|
- Run the CMOS
setup and check the CPU clock setting.
- If the clock
setting is correct, reboot the system.
- If the error
persists, contact the remote maintenance service center.
|
|
Onboard Serial Port 1 Conflict
|
Run the CMOS setup
and disable the port. |
|
Onboard Serial Port 2 Conflict
|
Run the CMOS setup
and disable the port. |
|
Onboard Parallel Port Conflict
|
Run the CMOS setup
and disable the port. |
|
Pointing Device Error
|
Run the CMOS setup
and disable the PS/2 mouse. A mouse is not used with this system. |
|
Pointing Device Interface error
|
Run the CMOS setup
and disable the PS/2 mouse. A mouse is not used with this system. |
|
Press F1 key to continue or B+A+^ for setup.
|
Press F1 to continue.
|
|
Real Time Clock Error
|
|
