Assigning a speech or DPR server

To assign a speech or DPR server:

1. From web administration, go to the Speech Proxy Administration screen (Feature Packages > Speech and DPR Administration > Administration).
2. Select Speech Recognition and DPR Configuration.

   The system displays the Speech Recognition and DPR Configuration screen. For information about this screen, see Speech Recognition and DPR Configuration screen.

3. In the Recognition Type field, select the recognition type for which you want to assign a speech or DPR server.
4. Select Assign New Server.

   The system displays the Assign Speech Recognition or DPR Server screen. For information about this screen, see Assign Speech Recognition or DPR Server screen

5. In the Server Name field, type the name of the speech or DPR server.

   If the server is an IBM WVS, type name/media, where name is the server's name.

6. In the IP Address field, type the IP address of the speech or DPR server.
7. In the Ports field, type the number of ports that are available on the speech or DPR server.

   Note:
   The number you specify must be less than or equal to the number of licensed ports for speech or DPR.

8. In the Base Port field, do one of the following:
   • Type 554 for a speech server with an IBM WVS (Port 554 is typically used for other MRCP-compliant engines as well.)
   • Type 2345 for a speech server with a WholeWord (Avaya Recognizer) speech recognition engine
   • Type 4904 for a speech server with a SpeechWorks OSR 2.0.4 speech recognition engine
   • Type 5111 for a speech server with a TDD modem recognition engine
   • Type 7500 for a speech server with a DPR engine
   • Type a port number greater than 1024 for a speech server with a Nuance speech recognition engine

     Note:
     For a Nuance speech recognition engine, the value for the Base Port field must be consistent with the RecClientPort defined in the Nuance npc batch file.

9. Select Submit.

   The system displays information about the success or failure of the administration attempt.

Repeat this procedure to assign additional servers to the same recognition type.

Administration changes do not take effect until you stop and start the voice system (see Stopping and starting the voice system).

© 2006 Avaya Inc. All Rights Reserved.