Assigning a TTS server with an MRCP engine

To assign a TTS server with an MRCP engine:

1. From web administration, go to the Speech Proxy Administration screen (Feature Packages > Speech and DPR Administration > Administration).
2. Select Text-to-Speech Configuration.

   The system displays the Text-to-Speech Configuration screen. For information about this screen, see Text-to-Speech Configuration screen.

3. In the Text-to-Speech Type field, select the TTS type for which you want to assign a server.
4. Select Assign New Server.

   The system displays the Assign Text-to-Speech Server screen. For information about this screen, see Assign TTS Server screen.

5. In the Server Name field, type the name of the TTS server.

   If the server is an IBM WVS, type name/media, where name is the server's name.

6. In the IP Address field, type the IP address of the TTS server.
7. In the Ports field, type the number of ports supported on the system.
8. In the Base Port field, type the number of base port you wish to set for the server.

   For the IBM WVS speech proxy server and the Nuance MRCP server, use 554.

   For the Scansoft SWMS proxy server, use 4900

9. Select Submit.

   The system displays information about the success or failure of the administration attempt.

Repeat this procedure to assign additional servers to the same TTS type.

Administration changes do not take effect until you stop and start the voice system (see Stopping and starting the voice system).

© 2006 Avaya Inc. All Rights Reserved.