|
This topic lists the tools, test equipment,
installation worksheets, and documentation
you must have to install and test the system.
Tools
The following tools are recommended for installing the system:
- A medium-width flat blade screwdriver
- A No. 2 Phillips screwdriver
- A small pair of needle nose pliers
- A small pair of wire cutters
- A sharp, pointed instrument such as a ballpoint pen
Caution! Do not use the point of a lead pencil.
The graphite can damage a circuit card and cause problems such as
electrical shorts.
Test equipment
Use the following test equipment when you install a system:
- A volt/ohm meter.
- Two telephones that are connected through the switch, if the
Message Networking system requires analog. The two test telephones
must be placed so that you can easily see the monitor while you
are using them.
Installation worksheets
Your project manager or systems consultant will give you a series
of worksheets prior to the installation. These worksheets have been
completed with input from the customer.
Documentation
Use the Message Networking online Help and documentation CD during installation
of a system. The Message Networking documentation provides information on installation
prerequisites and procedures necessary to perform hardware installation,
initial administration, acceptance testing, and troubleshooting.
Top of page
|
