|
An Avaya MAS supports up to 5 D/82JCT-U Digital Set Emulation
(DSE) Dialogic boards. For more information about installing DSE
boards, see the appropriate file for the type of DSE board you are
using:
- Dialogic D/82JCT-U (5V bus only): D82JCT-U
(pdf)
- Dialogic D/82JCT-U-PCI-UNIV (universal 5V or 3.3V bus): D82JCT-Univ
(pdf)
To set the jumpers for a new or replacement DSE board:
If more than one card is installed in the system, set up the
boards on either end of the Computer Telephony (CT) bus for bus
termination. Use the P8 jumper to set CT bus termination
as shown in the following table:
| Number of cards |
P8 jumper |
CT bus termination |
|
1
|
OFF |
bus not terminated |
|
2
|
ON pins 1 and 2 |
terminate bus on both boards |
|
3
|
Card 1: ON pins 1 and 2
Card 2: OFF
Card 3: ON pins 1 and 2 |
terminate bus on the end boards |
|
4
|
Card 1: ON pins 1 and 2
Card 2: OFF
Card 3: OFF
Card 4: ON pins 1 and 2 |
terminate bus on the end boards |
|
5
|
Card 1: ON pins 1 and 2
Card 2: OFF
Card 3: OFF
Card 4: OFF
Card 5: ON pins 1 and 2 |
terminate bus on the end boards |
See Setting D/82JCT-U board CT bus termination.
Top of page
|
