DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

Made Easy Tool for DEFINITY Media Server Configurations
Issue 5, October 2002



Install and Connect MCC1 (Multicarrier) Cabinet   

Install and Connect MCC1
(Multicarrier) Cabinet   

This section describes how to install the MCC1 (Multicarrier) cabinet. For information on Single-Carrier Cabinets, go to Install and Connect Single-Carrier Cabinets.

Floor plans and equipment layouts for typical system installations are provided in the System Description book.


Note: Before you begin the cabinet installation, check the location of the AC/DC power receptacles. The receptacles must be on separately fused circuits not controlled by wall switches. They must be located within 10 feet (3 meters) of the cabinet, and outside the Main Distribution Frame (MDF) area.

Task List: Install and Connect MCC1

Perform these tasks before you begin the installation:

  1. Check Customer's Order

  2. Unpack and Inspect Cabinets

  3. Unpack and Inspect Auxiliary Cabinet

  4. If you cannot get timing from the service provider, you may need to install a Stratum 3 clock. If this system includes a Stratum 3 clock, go to Installing the Stratum 3 Clock for instructions.

  5. Check Circuit Packs

  6. Correct Shipping Errors

Perform these tasks to install the cabinets:

  1. Position the PPN Cabinet

  2. Position the EPN Cabinets

  3. Position the Auxiliary Cabinet (Optional) and Install Auxiliary Cabinet Equipment

  4. If required, Install Earthquake Protection for MCC1


Danger! If the approved ground or approved floor ground can only be accessed inside a dedicated power equipment room, then connections to this ground should be made by a licensed electrician. See Approved Grounds for more information.

  1. Connect AC Power and Ground or Connect DC Power and Ground (These tasks have their own task lists.)

  2. Connect Remote Power Off Cable

  3. Connect External Alarm Cable

  4. Check Commercial Power and Connect AC Power

  5. Verify Fiber Optic Duplication Interface Cabling (TN792 port networks)

  6. Connect Fiber Optic Interconnect Cabling

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2002 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.