Made Easy Tool for DEFINITY Media Server Configurations
Issue 5, October 2002

Install and Connect SCC1 (Single-Carrier Cabinets)

---

Install Rear Panels

Return to Task List

1. Install the rear panels and loosely thread each screw. See Rear Panel Screw Locations.


2. For unstacked cabinets, tighten the screws securely.



For a stack of cabinets, allow the screws labeled callout 4 to remain loose. These screws are tightened when the ground plates are installed.

3. Be sure the Time Division Multiplexing (TDM) bus cables and the Inter-Cabinet Cables (ICC) are not pinched by the panels. Also be sure the cables are routed through the channels provided on the rear panels.

Rear Panel Screw Locations

Figure Notes:

1. Cabinet in A Position (No Ground Plate is Installed on an Unstacked Cabinet)


2. Rear Ground Plate (Attached Between Stacked Cabinets)


3. Cabinet in B Position


4. Screws to Loosen

Return to Task List

---

Copyright� 2002 Avaya Inc.

Send comments to MadeEasy Development Team

Always check at the Made Easy Web site for the most current information.