Previous page Next page

Continue server 2 configuration

If you upgraded the software:

  1. Under Server Configuration and Upgrades click Configure Server to restart the configure server process.

If you did not upgrade the software :

  1. Click through the Review Notices to get to the Copy Settings page.

With the copy settings screen configuration data, you can copy the settings from server 1 to server 2. Server 1 must be configured and running the same software version as server 2. The duplication link must be connected and the duplication interface must be up on the server 1.

Copy settings

If you want to copy the settings from media server 1 to media server 2, perform the following steps:

  1. Select "Copy configuration information from the duplicated server."
  2. From the drop down menu select server 2 and click Continue.
  3. On the second Copy Settings page verify that the duplication link Ethernet interface, IP addresses, and subnet mask are correct
  4. Click Continue and go to Update System.

Configuring manually

If you want to configure media server 2 step by step (as you did for server 1), perform the following steps:

  1. Select "Configure all services using the wizard."
  2. Click Continue to go to the Set Server Identities page.
  3. Fill in the fields on the Set Server Identities and the subsequent pages.

NOTE: Most of the fields are populated with default settings. Do not change the defaults unless the customer's network administrator requests it (refer to the filled-out job aid entitled Pre-Installation Network Planning Forms--S8700 Media Server).

Update System

  1. When the Update System page displays, click Continue to update the server.

NOTE: The media server is not configured until you click Continue on the Update System page.

The Update System screen displays each configuration task as it completes it. The last line says "System modifications completed."


Previous page Next page