Install the TN2501AP Circuit Pack��

WARNING: To prevent electrostatic discharge (ESD), be sure to wear a grounding strap while handling the circuit pack.

1. Insert the circuit pack into any port slot and close the latch securely.

At first, the red and green LEDs are on steady, then the green LED flashes. If there are announcements on the circuit pack, the amber LED flashes while the announcements are copied from FLASH to RAM. After about 3-5 minutes, all of the top 3 LEDs go out, although the time is longer if there are announcements already recorded on the circuit pack.

NOTE: If the TN2501AP circuit packs are at the MultiVantage software limit and you insert a VAL circuit pack, the red LED on that circuit pack stays on, indicating that the MultiVantage software does not accept it.

2. Connect the backplane adapter to the Amphenol connector on the back of the media gateway corresponding to the TN2501AP circuit pack slot.
3. Connect the LAN CAT5 cable to the RJ45 connector on the backplane adapter.