Changing default ip on Midsize Enterprise

[larsen2]

Hi guys
I’m installing a Midsize Enterprise 6.2 for the first time on a DL360 G7. The system platform is pre-installed. My problem now is, that I can’t change the default ip addresses and host names under Server Management -> Network Configuration. When I save and wait 7 minutes, it is still the old settings, that’s left. I have followed the Midsize intelligent workbook step by step until this.
I can see, in earlier post from March
14 that there is a note about this. It says that it is not possible to change the defaults, unless by reinstall with the DVD’s.
Can this be correct, and if so, what is the advantage by this pre-install ??
Hope anyone can help

Regards
DKL22

[larsen2]

No one has installed a Midsize Enterprise 6.2?

[garg19]

I have installed ME6.2 5 days back. I was able to change the default settings. You must be able to change the IPs and hostnames. But make sure that when you chnages them, they should not be used anywhere and DNS/NTP should be reachable.

Otherwise You can install the SP from starting with customer provided IPs etc.

[larsen2]

Thanks.
It was possible. After setting up the DNS server, it still didn't work. Then I tried to change from IE to Forefox, and then it worked. Now it responds as it should.

So the solution for me, was using Firefox instead of IE

Best regards
Larsen2

[agetor]

Confirmed, doesn't work with ie 8/9. Works with Firefox.

Tony