CM 6.3.X service pack installation

[pavel3]

I didn't find clear information about installing service packs for CM + Kernel Service Pack + PLAT Service Pack.
Should I remove previous SP or it will be done automatically?
I've installed 03.0.124.0-21588, after successful installation the state of previous sp is Installed (does it mean that it is unpacked as in cm 5.2.1), the state of this SP is Active. Could I Remove Previous SP?
Not Installed - uploaded but packed.
Installed - unpacked.

I have found "The previous Security Service Pack must be deactivated before activating a new Security Service Pack". What about other?

Version of CM in Virtual Machine management - Manage didn't change. I've also upgraded utility server to 6.3.5, but the version is 6.3.0. I can only see installed SP in Patch Management. Versions renew for SMGR, cdom, dom0.

[sumit007]

CM 6.3.X service pack installation

Hi Pavel3,
Till CM 5.2.1 you need to deactivate the previous SP's.
But in CM 6.x Most patches will installed from System platform only.
You dont need to do anything. After uploading the patch ( you need to upload the patch on System Platform 6.3 through patch management) . Just install it.
Rest of will take care by System.

But in case of PLAT and Security Patch You need to installed them from CM webpage.
by following the same procedure.