Cor + SIP Trunk

[maxvasquezcacho]

Hello,

I have a sip trunk between CM and CS1K. The CS1K is connected to the PSTN so when a CM's user makes an outbound call to the PSTN it goes to the SIP trunk and then to the CS1K to reach the PSTN.

Everything is ok, but when I create the cor table:

Cor 0 - Block calls (all user's have this cor configured)
Cor 1 - local calls
Cor 2 .- Cellphone calls
Cor 3 . national calls
Cor 4 - Interntational calls

However, nothing seems to work. The users made calls without ask for the authorization call.

I configured this before and working, but when the CM is connected direct to the PSTN via E1.

What's the problem when it refers to SIP trunk?

Thanks in advance

PS: I apologize for my english. I'm not a native speaker.

[ferna272]

Hello,

Have you checked the FRL in COR?


Regards.

[moyaw]

Hi,

You have to configure FRL in the all the CORs, for example

COR 0 --> FRL 0
COR 1 --> FRL 1
COR 2 --> FRL 2
COR 3 --> FRL 3
COR 4 --> FRL 4

then you have to configure route patterns for local, cellphone. national and international calls, for example: lets say trunk 10 is sip to CS1k

Pattern Name: local
SCCAN? n Secure SIP? n
Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 10 1 n user
2: n user

Pattern Number: 11 Pattern Name: cellphone
SCCAN? n Secure SIP? n
Grp FRL NPA Pfx Hop Toll No. Inserted DCS/ IXC
No Mrk Lmt List Del Digits QSIG
Dgts Intw
1: 10 2 n user
2: n user

do the same for national: route pattern 12, trunk 10, frl 3
do the same for international: route pattern 13, trunk 10, frl 4

THEN, define the ARS table to have outgoing calls

change ars analysis 0 Page 1 of 2
ARS DIGIT ANALYSIS TABLE
Location: all Percent Full: 0

Dialed Total Route Call Node ANI
String Min Max Pattern Type Num Reqd
00 10 20 13 intl n
02 9 9 12 natl n
09 10 10 11 locl n
2 7 7 10 locl n

the total min and max depends on your contry.

BTW sorry for my bad english too.