CM 7 install Dumb Question

[rogerg]

I have installed the CM 7.0 simplex VM on our LAB ESXi host. Everything is good, however when I login to ASA to setup basic translations, I am not able to see / access a change command.

I know in 6.x and earlier, I could install, but before I could add anything, I had to change system parameters maintenance, make any change, save trans then reset sys 4. ...then all would be available for 30 days...for testing (no licenses).

How do I do this in CM 7?

[hurdk]

I was offered the change command when it saw the weblm or SMGR address being used for licensing. I did however see all the commands after a restore when I did an upgrade and before the license was installed.

[derekf]

I haven't done a CM7 yet, but in CM6 I believe it was the auth file that needed to be installed, then reset sys 4 before you could make translation changes.

[hart105]

Thanks for sharing this, derekf! Been trying to figure out how to do this for quite some time now.

[hurdk]

I have installed quite a few and it will let you admin when it sees the license ip address and its valid.