about DHCP-Relay , need help !

[fan8]

ERS 5530 Software Ver: 6.2.5

VLAN 10: 192.168.8.254 255.255.255.0 PORTS:1,3
192.168.8.10 is the DHCP SERVER(Also supply BOOTP Service)


VLAN 20: 192.168.10.1 255.255.255.0 PORTS:7,9



Global : IP DHCP-RELAY enabled.
ip dhcp-relay fwd-path 192.168.10.1 192.168.8.10


interface:

interface vlan 20
ip dhcp-relay
ip dhcp-relay mode bootp_dhcp


in VLAN20 computer could not get the DHCP dynamic IP address
(DHCP Server 192.168.8.10 setup correctly.

why ?

need some extra setup ???

[kerya]

add the following command:


ip dhcp-relay fwd-path 192.168.10.1 192.168.8.10 enable
p dhcp-relay fwd-path 192.168.10.1 192.168.8.10 mode bootp-dhcp

[rspady]

So does dhcp-relay require both of these statements? It just seems kind of redundant to me.....
ip dhcp-relay fwd-path 1.1.1.1 2.2.2.2
ip dhcp-relay fwd-path 1.1.1.1 2.2.2.2 mode dhcp


I am looking at adding three new DHCP servers for a total of 6 and I am wondering if I am going to have to add these lines of code for each subnet for each DHCP server which will add an aweful lot of code for DHCP realy. Or is there a better way of doing this?

[itaiyebali]

Multiple DHCP server in DHCP relay

So does dhcp-relay require both of these statements? It just seems kind of redundant to me.....
ip dhcp-relay fwd-path 1.1.1.1 2.2.2.2
ip dhcp-relay fwd-path 1.1.1.1 2.2.2.2 mode dhcp


I am looking at adding three new DHCP servers for a total of 6 and I am wondering if I am going to have to add these lines of code for each subnet for each DHCP server which will add an aweful lot of code for DHCP realy. Or is there a better way of doing this?

Answer -
I believe it should take one DHCP server IP at one time, but depends on Product. Let me check and confirm you.