Is MFC R2 modified protocol supported with ACM 6.0.1 ?

[badozc]

Hello Dear community


We plan to implement a remote site using a MM710 B to be attached with MFC R2 modified line from Telmex in Mexico. This will run on a G450 and a LSP running ACM 6.0.1.

Is there any risk to be unable to bring the line up and running ?

Does any of you have sucessfully implemented this scenario and could provide some screen snapshot of a working config including DS1, trunk, ARS analysis and route pattern forms ?

A few years ago we failed to connect to a MFC R2 line in Romania and the customer is really not confident that we will be sucessful in Mexico.

Regards
Christophe

[mskinner]

Both the MM710 and the MM710B support R2MFC signaling.

[badozc]

Thank you mskinner for your interest about this question.
The real concern I have is that Telmex specified that it uses R2 MFC MODIFIED protocol. I have already lines in Brazil working fine but it was a standard protocol. So I am looking precisely configuration information that would assess our compatibility. We can always tell the customer that it won't work but I don't like to lie . If there is a chance to have it working let's make it work.
Regards.

[molexadmin]

Was anythnig determined from this? We have a Telmex trunk that was working and now they are only receiving the Trunk Group Name label. A list trace reveals the calling number information. I've looked into the multifrequency settings, verified against multiple KB articles on Avaya support, and verified with other posts in other forums. I am at a loss as to where it "broke".