ethernet port usage on DL360 g7 for ACM 6.2 duplex

[rime]

Hello, what are the current recommendations to assign functions to the ethernet ports of an ACM 6.2 duplex server?

Does this make sense?
eth 0 (physical port 1): dom0/cdom/ACM
eth 1 (physical port 2): service port
eth 2 (physical port 3): dom0/cdom/ACM (NIC bonding to eth0)
eth 3 (physical port 4): duplication

I read that for the formerly used S8800 server, the
second port for dom0/cdom/ACM was eth4 on the optional NIC.

Thanks

[rime]

doc about ethernet ports on ACM 6.2 servers

There is a white paper out there:
Implementation of Converged Control Network on Avaya Aura® Communication Manager 6.2

The following comment is of interest:

The choice of which interfaces to include in the bond should take into account that CM call control server interfaces are internally paired in dual port NIC devices (eth0/eth1, eth2/eth3, eth4/eth5) and the chosen interfaces should be from different NIC devices (e.g. eth2 and eth4 bonded). Bonding, eth0 with eth1, for instance, runs the risk that a failure of this single NIC device would leave both interfaces of the bond inoperable.

So I conclude that this should work:
eth0 and eth2: dom0/cdom/acm
eth1: service notebook
eth3: duplication