1608 2Phones Dead

[faqeel]

Hi guys,

We are facing strange issues with 1608 phones .. 2 phones at same location are doing nothing.. and showing junk data only!

any way to reset to factory default.. i tried 73738# but of no use.. or any other way to reload the firmware of the phones?

[zhonghuali]

Hi Sir,

For 1608 phone, please press Mute 27238# to reset the setting.

[aa1]

Hello, to reload the firmware, you can simply downgrade to an older release and then upgrade the phone again.

Here is the link to the 16xx phones

http://support.avaya.com/css/appmanager/public/support/Downloads/P0468/1.3.x

[faqeel]

Hi Sir,

For 1608 phone, please press Mute 27238# to reset the setting.

Thanks for the suggestion but its of no use.. what we do normally is after we press the mute button the IP Phone goes into config mode and we dont hear any beeps for the keys pressed.. but as you said i tried typing craft.. i.e. 27238# but it didnt work out its giving beeps on every key pressed!.

Hello, to reload the firmware, you can simply downgrade to an older release and then upgrade the phone again.

Here is the link to the 16xx phones
http://support.avaya.com/css/appmana...ds/P0468/1.3.x " .

We are getting Garbage data on Phone screens.. we dont know in what state the phone is .. we switch on the set with Power over Ethernet (POE)

we get Junk Data on screen as follows

Rqt0A AAUAO00000000000000000000000000
:0A 0AA wAq}000000000000000000000000000
00000000000000000000000000000000000000

while the fone is booting up the screen is in some movment state with same junk/ Garbage Data.

Any more solutions highly appreciated!

Regards

[uschwalbach]

2 phone death ?!

provides sufficient current to the switch? what a switch is it? Cisco switches can operate on the power and the current software manegmant for individual ports sat down.

[ista6]

I have seen this when there are power adapters are used.
Those power adapters do not fit very well and if you move the phone then the power is gone for a moment and the phone reboots.

The phones do get an ip address but that is all.
You can see this on the garbled screen (hex counting up)

The phones are probably broken.