9611 SIP Phones

[arobert1]

I have just installed 9611 SIP Phones.

• When I make calls to the 9611 SIP phones from H323 Phones all works as it should.
• When I make calls from SIP Phones to other SIP Phones the call completes and works as it should.
• When I make calls from the 9611 SIP Phones to H323 phones, I get an error 404 No route available.
• If I make a call using a 9611 SIP phone outside of the PBX the call completes.
• When I make calls using the SIP Conference phones to the H323 phones the call completes.

I have noticed in the "li tac traces" that there is a * (Star) before the phone number in the setup digits in the trunk trace. On the calls from the conference phones there is no * (star) and the calls complete, also when I dial the outside line there is no leading * (star) - these calls complete also.
This leads me to believe that the problem is the star but I do not know where to remove it.


Looking for thoughts on where I can remove the star or if the star is supposed to be there where to look next.

[arobert1]

I have cleared this by removing the Star in the dial plan. Looks like I did not apply the dial plan to the enity. After theis was done, this the issue cleared.