Problem with upgrade bcm400 to bcm450 r 6

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • vparedes
    Aspiring Member
    • Nov 2010
    • 1
    #1

    Problem with upgrade bcm400 to bcm450 r 6

    BCM U-Boot 1.2.1 (Jul 24 2008 - 11:05:06)

    CPU: 8567_E, Version: 1.1, (0x807d0111)
    Core: E500, Version: 2.2, (0x80210022)
    Clock Configuration:
    CPU:1333 MHz, CCB: 533 MHz,
    DDR: 266 MHz, LBC: 33 MHz
    QE: 533 MHz
    L1: D-cache 32 kB enabled
    I-cache 32 kB enabled
    Board: BMB450 R1.0
    I2C: ready
    DRAM: Initializing
    DDR: 512 MB
    POST: running... POST memory PASSED
    L2 cache 512KB: enabled
    RTC Clock needs to be set!!!
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector boundary
    Error: start and/or end address not on sector bounda
    Tags: None
  • nirmalsi
    Hot Shot
    .
    • Sep 2010
    • 10
    #2
    Problem with upgrade bcm400 to bcm450 r 6

    I have seen this error in past. These could be happening:
    -source BCM not patched latest
    -BFT connections is loose(try re fitting BFT)
    -BFT is bad and needs RMA

    Comment

    Previous template Next
    Loading