I have a CM6.3 connected to a Cisco UC with a SIP. I have identical extension #'s for a single station on each(x7123). I had put in a route to send calls to that ext over the sip trunk, and all was fine. I then took the route out(from the AAR) and calls keep going to both phones. Is there a place that caches's ip's. The Cisco is IP of course, but the CM station is digital. I tried removing and adding back both the signal group and the trunk, but as soon as I put them back, calls also get sent to the sip. My dialplan is just ext for 7123. I tried restarting the ip phone, but I think it's getting the same ip address. Any ideas?
Comment