Having a very strange issue....
On IP500 DS30 B modules - when connected to R11.1.2.1.0 Build 3 to R10 Control Unit test fine except port 6.
The powers up but the LED on port 6 goes solid, then goes out and starts to blink. This just repeats and the phone does not work. I've used multiple 1408/16's and different IPO's with R11.
Tried downgrading to R9 CU and it works fine ... back up to the R11.1 CU and port 6 always fails -
Multiple DS30B
Any ideas?
Thanks!
On IP500 DS30 B modules - when connected to R11.1.2.1.0 Build 3 to R10 Control Unit test fine except port 6.
The powers up but the LED on port 6 goes solid, then goes out and starts to blink. This just repeats and the phone does not work. I've used multiple 1408/16's and different IPO's with R11.
Tried downgrading to R9 CU and it works fine ... back up to the R11.1 CU and port 6 always fails -
Multiple DS30B
Any ideas?
Thanks!
.
Comment