Connecting 9608 through VPN on RV082 router

[feroz]

I'm a VPN noob trying to get a 9608 to hookup to Linksys/Cisco RV082 router (the 10.123.141.0/24 network is the internal network of the VPN router and the IP office is 10.123.141.2 and public IP of VPN router is 206.248.171.119 The phone is behind a NAT router with internal network 192.168.7.0/24 and the public IP is 70.51.118.43 with IPSEC/PPTP pass-through). I can connect with Quickvpn client and PPTP windows client to the remote VPN router ok but those are very easy to setup . I’ve included a screenshot of the VPN client to gateway configuration and below is my config on the phone done through menu under VPN setup:

VPN Vendor: Cisco
Gateway address: 206.248.171.119
External phone IP address: 10.123.141.100
External Router: 10.123.141.1
External Subnet mask: 255.255.255.0
External DNS server: 206.248.154.22
Encapsulation: 4500-4500
Copy TOS: No

Authorization Type: PSK

IKE ID (Group Name): [email protected]
Pre-shared Key (PSK): avayaissexy

IKE ID Type: USER_FQDN
IKE Xchg Mode: Aggressive
IKE DH Group: 1
IKE Encryption Alg: DES
IKE Auth. Alg: MD5
IKE config Mode: Enabled

IPsec PFS DH Group 2
IPsec Encryption Alg DES
IPsec Auth. Alg: MD5
Protected Network: 10.123.141.0/24

IKE over TCP Auto

Under Address are the following settings:

Phone(IPV4): 10.123.141.100
Call Server 10.123.141.2
Router(IPv4): 10.123.141.1
Mask(IPv4): 255.255.255.0
HTTP server: 10.123.141.2

I’m getting another one Bad gateway DNS name. Follow this link to view configuration on Linksys RV082 client to gateway tunnel. (picture is too big to attach)

http://dl.dropbox.com/u/81311903/rv082vpnsetup.JPG