Can't load hold music

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • chan333
    replied
    Originally posted by ista6 View Post
    It should be in the primary folder on the SD card.
    If not then it will not work.
    Dear expert,

    After I put the wave file into the primary folder on the SD card,
    should I boot the IPO500V2 afterwards?

    BR//
    Last edited by chan333; 11-07-2018, 12:11 AM.

    Leave a comment:


  • cfares
    replied
    they are lot of sofware open source for recording holdmusic.wav

    i use audacity for recording (open source)

    for my ip office , i have recording in 16 bit 8khz mono .wav

    wma is a compressed record and is bad.

    ip office permit use 3 differents record for holdmusic in a manager

    BESt regards

    Leave a comment:


  • lhandr
    replied
    Message on Hold

    I am relatively new to the IP Office and curious how to record the .wav file for the internal music on hold? I read you can use the Sound Recorder on a Windows PC but you had to set it to PCM, 16-bit, 8kHz, Mono. I am running a Windows 7 PRO laptop and it only lets me save as a .wma. What is the recommended procedure to record a message on hold with the required settings??

    Leave a comment:


  • driver
    replied
    Ok ,in the primary folder . It's running, thank you very much ¡¡

    Leave a comment:


  • ista6
    replied
    It should be in the primary folder on the SD card.
    If not then it will not work.

    Leave a comment:


  • driver
    replied
    I put it in the root directory of the system sd. I have another iP500V2 and does not work there but If it works in any version V1.
    Last edited by driver; 06-09-2010, 12:18 AM.

    Leave a comment:


  • ista6
    replied
    It should work.
    Where are you putting the file ?
    It should be in the primary folder.
    Do you get an error ?

    Leave a comment:


  • driver
    started a thread Can't load hold music

    Can't load hold music

    Hello, We have got a IP500V2 (version 6.0.8), I can't load hold music via tftp from system source as a wave file (holdmusic.wav). I think that all the configuration is ok. I've always used the holdmusic.wav in earlier versions. Is there some problem with this version?. Thank you.
Loading