Extending IP 500 to another site.
Hi Guys,
We have Avaya IP office 500 controller and few digital expansion modules in one of our sites. The plan is to stretch our LAN network and as part of this operation, we want to just move 2 of the existing digital expansion modules from Site-A to Site-B, but the phones in site-B should still be able to communicate with the IP 500 Controller card in Site-A. Can this be done?
The connection between site-A and Site-B will be 1Gig P-to-P connection. The plan is create a L2 trunk ports on each side between two cisco L3 switches and carry the Voice and Data ( vlan 5 and Vlan 25). Please note these phones are not VOIP enabled, so they only connect to digital modules. My question is how can i connect this DIG module in Site-B back to Site-B's IP Office 500 Controller? If i use a trunk between sites and then connect
IP office 500 Ctlr ---vlan5----Cisco 3560-----Trunk---------Cisco 3560----- Ip Office 500 DIG expansion Module ---- Avaya DIG Phone.
Many thanks
Rob
We have Avaya IP office 500 controller and few digital expansion modules in one of our sites. The plan is to stretch our LAN network and as part of this operation, we want to just move 2 of the existing digital expansion modules from Site-A to Site-B, but the phones in site-B should still be able to communicate with the IP 500 Controller card in Site-A. Can this be done?
The connection between site-A and Site-B will be 1Gig P-to-P connection. The plan is create a L2 trunk ports on each side between two cisco L3 switches and carry the Voice and Data ( vlan 5 and Vlan 25). Please note these phones are not VOIP enabled, so they only connect to digital modules. My question is how can i connect this DIG module in Site-B back to Site-B's IP Office 500 Controller? If i use a trunk between sites and then connect
IP office 500 Ctlr ---vlan5----Cisco 3560-----Trunk---------Cisco 3560----- Ip Office 500 DIG expansion Module ---- Avaya DIG Phone.
Many thanks
Rob
.
Comment