Hi,
We have an old IPOffice 406 and one of our analog modules burnt out, I have replaced it with a 16 port IP400 and its detected and has the correct firmware.
The issue is that it comes up as 16 lines rather than extensions and there is no dial tone. How do I make them analog extensions?
Any thoughts or suggestions greatly appreciated.
We have an old IPOffice 406 and one of our analog modules burnt out, I have replaced it with a 16 port IP400 and its detected and has the correct firmware.
The issue is that it comes up as 16 lines rather than extensions and there is no dial tone. How do I make them analog extensions?
Any thoughts or suggestions greatly appreciated.
Comment