IPO 500 V2--Can't get into Basic Mode

[manae]

Greetings,

I have an IPO 500 V2 out of the box that appeared to be on 9.0.x. I upgraded firmware to 9.1.1. The firmware loaded fine and shows as 9.1.1.

I go into the IPO for the initial config using Manager and it prompts me for the type. I select Basic and when the config opens, I get a bunch of errors. It seems that it opens a Standard config instead.

If I save the config and let it reboot, I get into an unlicensed standard mode. I then try to change it to Basic mode and I get an error that states: "Access Rights Ok, but not permitted to execute command."

Any ideas?

Thanks!
Ed

[ks120071963]

Hi Ed,

I'm having the same problem! I have also tried to recreate the SD and and this does not seem to help. Support in distribution has stated that they are getting reports of the same problem and no one seems to have a resolution to the problem.

Donald

[markgallagher]

In IP Office Manager, look at the application preferences (File | Preferences).

Ensure that the option 'Default to Standard Mode' is not selected (if selected it converts a Basic Edition config to non-Basic when you load the config into IP Office Manager).

If you only have Basic Edition systems you might want to select 'Set Simplified View as default'.

[pthiru]

Hi Mark,

I saved my first configuration in Basic mode without disabling "Default to Standard Mode" i got errors and warnings and prompted for Essential Edition license required, then i disabled Default to Standard Mode. I could not get IPO in working mode, it is new installation. Any suggestion please.

[byrdc]

I would go to File/Advanced/ Erase Configuration, and clear the config and start over.

[rdagur]

Hi all ,
creat a offline configration on basic mode then upload in avaya its a best way.

File-----offline----creat new conf ---