Avaya ERS 3500 uplink ports configuration

[bslons]

Hi All

Could someone explain me how should I configure fiber uplink ports on Avaya switch ERS3500 according to below picture.




Vlan 10 is untagged management vlan.


Question 1
for fiber links I need to configure MLT trunk right ? Could someone possibly post configuration example for that port? Shall I be aware of something here?



Question 2
Ubiquiti APs are connected directly to the Avaya switches. They will get IP from Vlan 10. I don't know how to configure the port where APs are connected to accept untagged traffic from Vlan10 and tagged from Vlan20, 30, 40.


I am familiar with Cisco devices and how this is configured there, but not sure how to make it working on Avaya switches.
I would highly appreciate is someone could guide me through. Ideally posting configuration example.



Regards,

[zakabog]

Question 1
for fiber links I need to configure MLT trunk right ? Could someone possibly post configuration example for that port? Shall I be aware of something here?

Look at your image, you have one link per device, so there's no need for MLT.

Question 2
Ubiquiti APs are connected directly to the Avaya switches. They will get IP from Vlan 10. I don't know how to configure the port where APs are connected to accept untagged traffic from Vlan10 and tagged from Vlan20, 30, 40.

You want vlan 10 to be the native untagged VLAN? So if I plug a device in with no VLAN configuration you want it to be on VLAN 10 by default? Or do you just want it on port 21 on each switch?