Configure file as per instructions contained on file.
http://marketingtools.avaya.com/knowledgebase/businesspartner/index.html
##################### 802.1X SETTINGS ####################
##
## DOT1XSTAT specifies the 802.1X Supplicant operating mode.
## Value Operation
## 0 Supplicant disabled (default, unless indicated otherwise below)
## 1 Supplicant enabled, but responds only to received unicast EAPOL messages
## 2 Supplicant enabled; responds to received unicast and multicast EAPOL messages
## This parameter is supported by:
## 96x1 H.323 R6.0 and later
## 96x1 SIP R6.0 and later
## 96x0 H.323 R2.0 and later
## 96x0 SIP R2.0 and later (default was 1 prior to R2.4.1)
## 46xx H.323 R2.9 and later (default was 1)
## 1603 SIP R1.0 and later
## SET DOT1XSTAT 1
##
## DOT1X specifies the 802.1X pass-through operating mode.
## Pass-through is the forwarding of EAPOL frames between the telephone's
## Ethernet line interface and its secondary (PC) Ethernet interface
## Value Operation
## 0 EAPOL multicast pass-through enabled without proxy logoff (default)
## 1 EAPOL multicast pass-through enabled with proxy logoff
## 2 EAPOL multicast pass-through disabled
## This parameter is supported by:
## 96x1 H.323 R6.0 and later
## 96x1 SIP R6.0 and later
## 96x0 H.323 R2.0 and later
## 96x0 SIP R2.0 and later
## 46xx H.323 R2.9 and later
## 1603 SIP R1.0 and later
## Note: In 96x0 H.323 releases 1.0 through 1.5, and in 46xx H.323 releases 2.6 through 2.8,
## DOT1X is supported, but it controls both Supplicant and pass-through operation.
## In these releases, operation is as follows:
## Value Operation
## 0 Unicast Supplicant and multicast pass-through enabled without proxy logoff (default)
## 1 Unicast Supplicant and multicast pass-through enabled with proxy logoff
## 2 Unicast or multicast Supplicant operation enabled, without
