New G450 show "insertion failure" when running command "show mm"


Doc ID:    SOLN285478
Version:    1.0
Status:    Published
Published date:    11 Mar 2016
Author:   
Bryan Case
 

Details

When running the command show MM in the G450 to view all the cards, it  shows "Insertion Failure"

The cards have been changed to know working G450's with no issues so the problem is not a card issue.
Edwin also installed a new G450 and receive the same fault.
Boards are not showing when doing show MM in G450
G450 Firmware 36.16.0

Problem Clarification

When running command 'show mm" G450 shows insertion Failure

Cause

G450 software issue

Solution

run command on G450  "nvram init" to reset back to default and reload configure the G450

Resolved issue


Please rate this article

Avaya -- Proprietary. Use pursuant to the terms of your signed agreement or Avaya policy