Assigning templates to zones or edges
To assign alarm templates to zones or edges:
Access Chatter Alarm Configuration command mode. To access this mode, enter the following commands:
a.
enable
(Privileged mode)
b.
configure terminal
(Configuration mode)
c.
module chatter
(Chatter Configuration mode)
d.
alarm name
<name>
(Chatter Alarm Configuration command mode)
Use the commands in
Table 14
to assign alarm templates to zones or edges.
Table 14: Alarm template: assign zone or edge commands
Command
Purpose
set-alarm edge
Assigns an alarm template to a Chatter edge. Each edge can have one alarm template assigned.
set-alarm zone
Assigns an alarm template to a Chatter zone. Each zone can have one alarm template assigned.
