Previous page Next page

Procedure

To disable relative alarms for a test type:

  1. Access Chatter Alarm Configuration command mode. To access this mode, enter the following commands:
a. enable (Privileged mode)
b. configure terminal (Configuration mode)
c. module chatter (Chatter Configuration mode)
d. alarm name <name> (Chatter Alarm Configuration command mode)
  1. Use the commands in Table 13 to disable relative alarms for a test type. You can disable relative alarms for specific test variables or all variables.
Table 13:  Alarm template: disable relative alarm commands  
Command
Purpose
Disables relative alarms for RTP tests on any zone or edge that is assigned this alarm template.
You can control generation of relative alarms for each variable individually or all variables collectively.
Disables relative alarms for Ping tests on any zone or edge that is assigned this alarm template.
You can control generation of relative alarms for each variable individually or all variables collectively.
Disables relative alarms for Traceroute tests on any zone or edge that is assigned this alarm template.
You can control generation of relative alarms for each variable individually or all variables collectively.
Disables relative alarms for TCP tests on any zone or edge that is assigned this alarm template.
You can control generation of relative alarms for each variable individually or all variables collectively.

Previous page Next page