Administer the IP Interface
Return to Task List
Administration is done either locally or remotely. If administered locally, proceed with the following administration steps. If administered remotely, call your service representative to start the process.
- Type
change node-names and press
Enter.
- On Node Names - Screen 2, type in the node name and IP address for the TN802B.
- Type
change circuit-pack and press
Enter.
- On Circuit Packs - Screen 1, check the Code column to see if it says DSMAPD or MedPro.
- If not, type
MEDPRO in the slot just above TN802B slot, and press
Enter. Changing the one entry automatically changes the entry above it. If it is in IP Trunk mode, you get the following error message:
MedPro type requires TN802 with application. Type
MEDPRO on circuit-packs form.
- Type
change ip-interfaces and press
Enter.
- On IP Interfaces - Screen 1, type in the information for the TN802B IP Interface,
- Set the
Enabled field to
y, and press
Enter.
At this time the TN802B LCD reads
PC BOOT *, and about 3 to 4 minutes later reads
MEDPRO * with the asterisk flashing.
Node Names - Screen 2