DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Install and Connect Multi-Carrier Cabinets   

Connect DC Battery Cabinet to DC Power Cabinet

Return to Task List


Note: The wire in the next step must be sized for a maximum voltage drop of 0.5 VDC in each leg of the DC distribution. In this example 1 AWG is used.

  1. Turn off the main circuit breaker on the DC Battery Cabinet.

  2. Turn off the main circuit breaker on the DC Power Cabinet.

  3. Measure and cut a 6 AWG (#40) (16 mm 2) wire long enough to reach from the DC Battery Cabinet's -48 Volt DC terminal to a DC OUTPUT distribution bus on the DC Power Cabinet.

  4. At the DC Battery Cabinet, connect the -48 volt DC wire to the -48 VDC connector.

  5. Route the wire out of the cabinet through the hole in the lower rear cover and to the DC Power Cabinet.

  6. At the DC Power Cabinet, terminate the -48 volt DC wire on a DC OUTPUT distribution bus.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.