DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



G3iV4 to R10si (On-Site)

Save translation, duplicated system [G3V4 to R10si]

Return to Task List

To save translations on duplicated systems, the systems must be in sync or the command will fail. Both switch processing elements (SPEs) must be functional: one in active mode and the other in standby mode.

  1. Execute status system 1 before you save translations.

    2. Verify that conditions are normal -- this can take a few minutes. If the system is not in a normal condition, refer to the maintenance procedures; if maintenance fails, escalate the problem. DO NOT PROCEED!

  2. Type save translation and press Enter.

    3. This takes about 10 minutes.


Note: Do not press any keyboard key until after the terminal displays the success message. For example, if you press Enter more than once after typing the command, the second Enter erases the screen and you never see the success message.

  1. If the save translation command fails, do not continue. Record the error code that appears on the screen and escalate the problem immediately.

Store the translation media in a safe and secure place. In case of failure, you use this translation to restore the system.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.