DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



G3iV4 to R10si (On-Site)

Shut down DEFINITY AUDIX system [G3V4 to R10si]

Return to Task List

A yellow caution sticker on the system's power unit notifies you to shut down the AUDIX before powering down the system.


Caution! Electrostatic discharge can severely damage sensitive electronic circuits. Before handling any electronic hardware, be sure to wear a grounding wrist strap or other static-dissipating device.


Danger! Neglecting to shut down an AUDIX assembly before powering down the system cabinet where it resides can damage the AUDIX disk.

  1. Log into the AUDIX as craft.


Note: If you have a dadmin login and password, you can use them instead of craft and the craft password.

  1. Type reset system shutdown and press Enter.

  2. Press Enter again to start the shutdown.

    3. The SHUTDOWN Completed message displays when the AUDIX is successfully shutdown. This takes about 2 minutes.


Caution! If leaving AUDIX System in the carrier, back it out about 2 in. (5 cm) to eliminate the possibility of damage due to power surges.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.