DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



G3iV4 to R10si (On-Site)

Set date, time, and daylight savings rule [G3V4 to R10si]

Return to Task List


Caution! It may be necessary to reseat circuit packs. To prevent damage from static electricity, always wear an Electromagnetic Compatibility (EMC) wrist strap (comcode 900698226) when handling all system components.


Note: To prevent unnecessary trouble tickets, do not enable the system alarms (Alarm Origination feature) until all installation and administration procedures are completed.

  1. Power up the AC- or DC-powered system.

For Single Carrier Cabinets
System
Steps

AC


    1. Set the switch on the AC power panel to ON position (up).

    2. Set the cabinet circuit breakers to ON.

      3. This starts the system initialization and test. All red LEDs on the circuit packs go on and then off.

DC
    1. At the DC Battery Cabinet (if installed), set the circuit breaker to ON.

    2. At the DC Power Cabinet, set the circuit breaker(s) on the rectifiers to ON.

      3. This starts the system initialization and test. Some red LEDs may be turned on, but they are turned off during the boot-up process. No action is required.

The results of system tests display on the monitor.

  1. Verify that all tests pass.

    2. If any of the terminal messages indicate a test has failed or if the message spe down mode is displayed, refer to DEFINITY ECS Maintenance for R10si to clear the trouble.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.