DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



G3iV4 to R10si (On-Site)

Save announcements and translation (TN750 or TN750B only) [G3V4 to R10si]

Return to Task List

  1. Remove the original translation card(s) from the TN2401 NetPkt circuit pack(s). These cards are read-only in the new TN2401.

  2. Insert the new translation card(s) into the TN2401 NetPkt circuit pack(s).

  3. Type save announcements and press Enter.


Note: Use this step only for systems equipped with the TN750 or TN750B announcement circuit pack. Skip this step for systems equipped with the TN750C or TN2501AP integrated announcement circuit packs, which contain on-board, nonvolatile memory.

This takes about 45 minutes.

  1. Type save translation and press Enter.

    2. This takes about 20 minutes.


Note: Do not press any keyboard key until after the terminal displays the success message. For example, if you press Enter more than once after typing the command, the second Enter erases the screen and you never see the success message.

  1. If the save translation command fails, do not continue. Record the error code that appears on the screen and escalate the problem immediately.

    2. Keep the translation media in a safe and secure place.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.