DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



R5/R6/R7/R8si to R10si

Replace TN772 duplication interfaces with the TN792 duplication interfaces (R6si or earlier) [R10si]

Return to Task List

  1. Remove the TN772 Duplication Interface circuit packs and place them in antistatic packing material.

    2. Leave the existing duplication cables connected to the backplane. The fiber optic cable connecting the new TN792 Duplication Interface circuit packs does not replace these cables.

  2. Insert the TN792 Duplication Interface circuit packs into the slots labeled DUPN INTFC.

  3. If the R10si carrier is located in a Multicarrier Cabinet, attach the 14-in. fiber optic cable to the faceplates of the installed TN792 Duplication Interface circuit packs (see Fiber optic cable connecting the two TN792 duplication interface circuit packs (multicarrier cabinet only)).

    or

    If the R10si carrier is in a Single-Carrier Cabinet, then attach the 10-ft fiber optic cable to the faceplates of the installed TN792 Duplication Interface circuit packst.

Fiber optic cable connecting the two TN792 duplication interface circuit packs (multicarrier cabinet only)

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.