Power up the system [R10si]

DEFINITY Made Easy Tools
Issue 3, December 2001

R5/R6/R7/R8si to R10si

Power up the system [R10si]

Return to Task List

Caution!

It may be necessary to reseat circuit packs. To prevent damage from static electricity, always wear an Electromagnetic Compatibility (EMC) wrist strap (comcode 900698226) when handling all system components.

Note:

To prevent unnecessary trouble tickets, do not enable the system alarms (Alarm Origination feature) until all installation and administration procedures are completed.


For Single Carrier Cabinets
System	Steps
AC	Set the switch on the AC power panel to ON position (up). Set the cabinet circuit breakers to ON. This starts the system initialization and test. All red LEDs on the circuit packs go on and then off.
DC	At the DC Battery Cabinet (if installed), set the circuit breaker to ON. At the DC Power Cabinet, set the circuit breaker(s) on the rectifiers to ON. This starts the system initialization and test. Some red LEDs may be turned on, but they are turned off during the boot-up process. No action is required.

The results of system tests display on the monitor.

Verify that all tests pass.

If any of the terminal messages indicate a test has failed or if the message spe down mode is displayed, refer to DEFINITY ECS Maintenance for R10si to clear the trouble.

Return to Task List

Send comments to MadeEasy Development Team

Always check at the Made Easy Web site for the most current information.