| |
System Speed Dial |
|
Personal Speed Dial |
Personal Speed Dial numbers can be used only with the following:
When you are programming Personal Speed Dial on MLX-5D, MLX-10D, MLX-10DP, or MLX-16DP telephones, select Enter from the display after dialing the telephone number. Otherwise, the number is not programmed.
A number dialed by using a marked System Speed Dial code overrides any calling restrictions (such as toll or outward restrictions) assigned to the extension.
The following special characters can be used in numbers programmed for Speed Dial codes: Pause (Hold), Stop (Drop for MLX telephones and Trnsfr for ETR and 4400-Series telephones), Flash (Conf), and End of Dialing (#). See Appendix H, Programming Special Characters, for additional information.
When a pool dial-out or ARS code is included in the dialing sequence associated with a Personal Speed Dial or System Speed Dial code, pauses may be required immediately after the dial-out code to allow time to receive outside dial tone.
Personal and System Speed Dial cannot be used at rotary dial telephones.
Personal Speed Dial can be used at digital data and modem-only workstations, but must be programmed through centralized telephone programming.
On multiline telephones, line buttons can be programmed with individual System Speed Dial codes. Each System Speed Dial code must be programmed on a separate button.
Personal Speed Dial should not be confused with Personal Directories. See Directories for more information.
The first Personal Speed Dial number (code 01) programmed for a single-line telephone is used by the HotLine feature. This inside or outside number is dialed automatically when a user goes off-hook at a single-line telephone programmed as a HotLine. The Personal Speed Dial number may be programmed at the telephone prior to its being assigned as a HotLine extension. Once the extension is programmed as a HotLine extension, programming at the extension can occur only once, and any further programming for the HotLine extension must be performed through centralized programming.
| Topics | |||||
| |
Description | ||||
|
|||||
| |
At a Glance | ||||
| |
Considerations & Constraints | ||||
| |
Mode Differences | ||||
| |
Telephone Differences | ||||
|
Feature Interactions | ||||