The following table lists the procedures for adding a new Serenade
Digital remote machine to the Message Networking system. The procedures appear
in the sequence in which they are performed.
| Completed |
Task |
| |
Verify that the Serenade system is enabled for digital networking
by running list slots and checking for a LAN card on
the Serenade. |
| |
Obtain the completed planning worksheet for the remote machine.
You will use the information from this worksheet when you configure
the remote machine parameters for the new Serenade machine. |
| |
Obtain the Dial Plan Mapping requirements for the remote machine
from your account representative. You will use these requirements
to determine how to map the new system's dial plan. |
| |
Determine the type of subscriber update to use for the new
system (Full, Dynamic, or Directory View). You will select the
subscriber update type when you add the remote machine to the
Message Networking system. |
| |
Administer the Message Networking system as a Serenade network
node on the Serenade system:
- Add the Message Networking system as a new location on
the Serenade system.
- Add a numbering plan for the Message Networking system.
The key information you need to complete these tasks is provided
on the General Parameters page
on the Message Networking system:
- The Message Networking name, IP address, and serial number.
The Serenade system uses this information to send messages
to the Message Networking system.
- The Message Networking network address length.
|
| |
Ping the Message Networking system from the Serenade Digital system using
the Ping command. |
| |
Administer the remote machine
parameters for the new Serenade Digital remote machine. |
| |
Administer the Dial Plan Mapping
for the remote machine, using the Dial Plan Mapping requirements
you obtained. |
| |
Administer the Serenade
Digital sender dial plan for the remote machine, if appropriate. |
| |
Administer directory views, if
appropriate. |
| |
Verify that the remote machine has been added to the Message
Networking system:
|
| |
Test LAN connectivity by transmitting
test packets. |
| |
Perform a remote machine connectivity
test. |
| |
Run NameSend from the Serenade system to the Message Networking
system. |
| |
Verify the NameSend update by viewing
the Subscriber List by Machine Name on the Message Networking
system. |
| |
(Optional) Run a Demand Remote
Push to the Serenade system to manually update the Serenade
system. |
| |
Update existing remote machines in the Message Networking network for
subscribers on the new Serenade Digital system. The Adding
and updating subscribers overview provides information on
how subscribers are updated for the different types of remote
machines. |
