DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC

DEFINITY Made Easy Tools
Issue 3, December 2001



Install and Connect Single-Carrier Cabinets

Install on a wall without a plywood backing plate

  1. Hold the unit at the desired locaton and mark the four hole (slots and keyholes) centers with a pencil.


Note: The J58890CG DC Power Distribution Unit should be installed to the right of the SCC Cabinet Stack and mounted approximately 12 inches (30.5 cm) off the floor.

  1. Use a level to make sure the power unit is straight, then set the unit aside and install four ZINC drywall "screw-in" anchors rated for at least 50 lbs each.

  2. Install the top two screws supplied with the zinc anchors.

  3. Mount the power distribution unit on the top screws and install the bottom screws through the slots in the power distribution housing.

Return to Task List

DEFINITY Made Easy Home Page Table of contents Previous page Next page Index Links Frequently asked questions
Go to Upgrades for si Go to Installation for MCC Go to Installation for SCC
Copyright� 2001 Avaya Inc.
Send comments to MadeEasy Development Team



Always check at the Made Easy Web site for the most current information.