Tape Drive: Check the active tone-clock (High/Critical reliability only) [R9r]

DEFINITY Made Easy Tools
Issue 2, November 2000

G3rV2/3/4 and R5/6/7/8r to R9r

Tape Drive: Check the active tone-clock (High/Critical reliability only) [R9r]

Return to Task List

Type status port-network 1 and verify that the Tone-Clock is in the same carrier as the active SPE and that the Service State field shows in.

If the Tone-Clock is not in the same carrier as the active SPE, type set tone-clock [A | B] to set the Tone-Clock to be in the active SPE.

Note:

This takes 1 minute to complete. If the service state is incorrect, repeat the command until this condition is met.

If the active Tone-Clock has not migrated to the active carrier after 1 minute, then a Tone-Clock problem exists. Refer to the TDM-CLK Maintenance Objects section of the DEFINITY Enterprise Communications Server Release 9 Maintenance for R9r book to resolve any problems.

Return to Task List

Send comments to MadeEasy Development Team

Always check at the Made Easy Web site for the most current information.