Upgrading a TN802 V3 (or later) to a TN802B (MedPro Mode)
Return to Task List
This section includes general information on adding the TN802/TN802B in MedPro mode and the Task list: Upgrade a TN802 to a TN802B.
If you have a TN802 V3 (or later) IP Interface, you must either replace it with a TN802B circuit pack or upgrade the existing TN802 V3 (or later) circuit pack to operate in MedPro mode. Also, to operate in the MedPro mode, the DEFINITY ECS switch must be R10 or later.
To upgrade the TN802 to a TN802B, you need the following hardware:
- Monitor, keyboard, and mouse to access the IP Interface's Windows NT environment or pcANYWHERE software.
- 10-Mbyte SanDisk PCMCIA flashcard loaded with the MedPro NT Application Install Wizard
- TN802B label
The upgrade adds or modifies the following directories or files on your computer's hard drive:
c:\dolan\*
c:\mapd\dnld\medpro.img
c:\mapd\dnld\tmp.img
Task list: Upgrade a TN802 to a TN802B
Perform these tasks in order:
- Connect the Monitor, Keyboard, and Mouse
- Upgrade IP trunks (R7) to H.323 trunks
- Upgrade to TN802B (R10)
- Verify Circuit Packs
