Position the Cabinets (Standard Reliability)

Before beginning the cabinet installation, check the location of the AC/DC power receptacles. The receptacles must be on separately fused circuits not controlled by wall switches. They must be located within 10 feet (3 meters) of the cabinet, and outside the Main Distribution Frame (MDF) area.

Refer to the serial numbers and lettered designation strips in the Customer Service Document (CSD) when stacking the cabinets. If earthquake protection is required, skip to Install Earthquake Protection for SCC. Return to this section when finished.

Perform this step first for all standard reliability cabinet installations.

Install the cabinet stack (processor port network)

Place Control Cabinet A (J58890L) on the floor in the position determined when the room layout was planned.

Set Port Cabinet B (J58890H) on top of Control Cabinet A.

Set Port Cabinet C (J58890H) on top of Port Cabinet B.

Set Port Cabinet D (J58890H) on top of Port Cabinet C.

If additional cabinet stacks are being installed, install the second cabinet stack (EPN)

Place the Expansion Control Cabinet (J58890N) on the floor next to Control Cabinet A. See previous instructions.

Set Port Cabinet B (J58890H) on top of the Expansion Control Cabinet.

Set Port Cabinet C (J58890H) on top of Port Cabinet B.

Set Port Cabinet D (J58890H) on top of Port Cabinet C.

If three cabinet stacks are being installed, install the third cabinet stack (EPN).

Place the second Expansion Control Cabinet (J58890N) on the floor next to the first Expansion Control Cabinet. See previous instructions.

Set Port Cabinet B (J58890H) on top of the Expansion Control Cabinet.

Set Port Cabinet C (J58890H) on top of Port Cabinet B.

Set Port Cabinet D (J58890H) on top of Port Cabinet C.

Return to Task List

Send comments to MadeEasy Development Team

Always check at the Made Easy Web site for the most current information.