|
This topic provides information on performing call progress tone
administration on the Message Networking system. Default tones are
provided for each supported switch. However, you can use the Tones
Administration pages to capture and evaluate tones, and to tune
the default tones if necessary for your system.
Note: Before performing tones administration, you must make
the connections to the switch, install
the switch software, administer the
voice system, and select the
switch.
There are multiple pages associated with Tones Administration:
- Tones Administration
page: The initial Tones Administration page displays the current
settings for each of the defined tones. Each tone is specified
in terms of Frequency 1 and/or 2, and the timing on and off cycles.
You cannot modify the tone settings directly on this page.
- Tone-specific pages:
There is a separate page for each tone listed on the Tones Administration
page. To access the tone-specific pages, click the name of the
tone on the Tones Administration page. For example, to modify
the Busy Tone settings, click BUSY TONE in the table on
the Tones Administration page. You can use the tone-specific pages
to modify the settings for each tone and to use the Tone Capture
tool, which allows you to capture the actual tone to determine
if you need to modify the system defaults for the tone.
- Tone Capture settings
page: The Tone Capture settings page lists the settings for
the Tone Capture tool. Configure the Tone Capture tool settings
if you want to capture any tones. To access the Tone Capture tool
settings, click Capture Setting on the Tones Administration
page. To launch the Tone Capture tool, click Capture on
any of the tone-specific pages.
Progress tone administration includes the following tasks:
Top of page
|
